Mercedes-benz 2013 C Class Coupe User Manual download pdf (Page 307)

You should test every position for at least

25 seconds before trying another position.

X

Press and hold button B on remote control

A until indicator lamp : lights up green.

If indicator lamp : lights up green or

flashes, then programming has been suc-

cessful.

X

Release button B of remote control A of

the garage door drive.

X

If indicator lamp : blinks red: repeat the

programming process for the correspond-

ing button on the rear-view mirror. When

doing so, vary the distance between remote

control A and the rear-view mirror.

i

If the indicator lamp flashes green after

successful programming, the garage door

system is using a rolling code. After pro-

gramming, you must synchronise the

garage door opener integrated in the rear-

view mirror with the receiver of the garage

door system.

Synchronising the rolling code

Observe the "Important safety notes"

(Y page 304).

Your vehicle must be within range of the

garage door or exterior gate drive. Make sure

that neither your vehicle nor any persons/

objects are present within the sweep of the

door or gate.

X

Turn the key to position 2 in the ignition

lock.

X

Press the programming button of the door

or gate drive (see the door or gate drive

operating instructions, e.g. under "Pro-

gramming of additional remote controls").

i

Usually, you now have 30seconds to ini-

tiate the next step.

X

Press previously programmed button ;,

= or ? of the integrated garage door

opener until the door closes.

The rolling code synchronisation is then

complete.

Problems when programming

If you have problems when programming the

integrated garage door opener, please note

the following:

R

Check the transmitter frequency of garage

door drive remote control A. This can usu-

ally be found on the back of the remote

control.

R

Replace the batteries in garage door

remote control A. This increases the like-

lihood that garage door remote control A

will transmit a strong and precise signal to

the integrated garage door opener in the

rear-view mirror.

R

When programming, hold remote control

A at varying distances and angles from the

button which you are programming. Try var-

ious angles at a distance between 5and

30 cm or at the same angle but at varying

distances.

R

If there is another remote control for the

same garage door drive, perform the pro-

gramming steps again using this remote

control. Before performing these steps,

make sure that new batteries have been

fitted in garage door drive remote control

A.

R

Note that some remote controls transmit

only for a limited period (the indicator lamp

on the remote control goes out). Press but-

ton B on remote control A again before

transmission ends.

R

Align the aerial cable of the garage door

opener unit. This can improve signal recep-

tion/transmission.

Opening or closing the garage door

Once programmed, the integrated garage

door opener will assume the function of the

garage door system's remote control. Please

also read the operating instructions for the

garage door system.

Features

305

Stowing and features

Z

1 2 ... 302 303 304 305 306 307 308 309 310 311 312 ... 387 388

Comments to this Manuals

No comments