Mercedes-benz 2013 E Class Coupe User Manual download pdf (Page 334)

X

Press and hold one of buttons ; to ? on

the integrated garage door opener.

After a short time, indicator lamp : lights

up yellow.

i

Indicator lamp : lights up yellow as soon

as button ;, = or ? is programmed for

the first time. If the selected button has

already been programmed, indicator

lamp : will only light up yellow after ten

seconds have elapsed.

X

Release button ;, = or ?. Indicator

lamp : flashes yellow.

X

Point garage door remote control A

towards buttons ; to ? on the rear-view

mirror at a distance of 2 to 8 inches (5 to

20 cm).

i

The required distance between remote

control A and the integrated garage door

opener depends on the garage door drive

system. Several attempts might be

necessary. You should test every position

for at least 25 seconds before trying

another position.

X

Press and hold button B on remote control

A until indicator lamp : lights up green.

If indicator lamp : lights up green or

flashes, then programming has been

successful.

X

Release button B on remote control A for

the garage door drive system.

X

If indicator lamp : lights up red: repeat

the programming procedure for the

corresponding button on the rear-view

mirror. When doing so, vary the distance

between remote control A and the rear-

view mirror.

i

If the indicator lamp flashes green after

successful programming, the garage door

system is using a rolling code. After

programming, you must synchronize the

garage door opener integrated in the rear-

view mirror with the receiver of the garage

door system.

Synchronizing the rolling code

Observe the "Important safety notes"

(Y page 331).

Your vehicle must be within reach of the

garage door or exterior gate drive. Make sure

that neither your vehicle nor any persons/

objects are present within the sweep of the

door or gate.

X

Turn the SmartKey to position 2 in the

ignition lock.

X

Press the program button of the door or

gate drive (see the door or gate drive

operating instructions, e.g. under

"programming of additional remote

controls").

i

Usually, you now have 30seconds to

initiate the next step.

X

Press previously programmed button ;,

= or ? of the integrated garage door

opener until the door closes.

The rolling code synchronization is then

complete.

Notes on programming the remote

control

Canadian radio frequency laws require a

"break" (or interruption) of the transmission

signals after broadcasting for a few seconds.

Therefore, these signals may not last long

enough for the integrated garage door

opener. The signal is not recognized during

programming. Comparable with Canadian

law, some U.S. garage door openers also

feature a "break".

Proceed as follows:

R

if you live in Canada

R

if you have difficulties programming the

garage door opener (regardless of where

you live) when using the programming

steps

332

Features

Stowage and features

1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 431 432

Comments to this Manuals

No comments