Mercedes-benz 2004 E 320 User Manual download pdf (Page 259)

259

Controls in detail

Useful features

Programming or reprogramming the in-

tegrated remote control

Step 1:

왘 Switch on ignition.

Step 2:

왘 If you have previously programmed an

integrated signal transmitter button

and wish to retain its programming,

proceed to step 3. Otherwise, press

and hold the two outer signal transmit-

ter buttons 1 and 3 and release

them only when the indicator light be-

gins to flash after approximately 20

seconds (do not hold the button for

longer than 30 seconds). This proce-

dure erases any previous settings for

all three channels and initializes the

memory. If you later wish to program a

second and/or third hand-held trans-

mitter to the remaining two signal

transmitter buttons, do not repeat this

step and begin directly with step 3.

i

Certain types of garage door openers

are incompatible with the integrated

opener. If you should experience diffi-

culties with programming the transmit-

ter, contact your authorized

Mercedes-Benz Center, or call

Mercedes-Benz Customer Assistance

Center (in the USA only) at

1-800-FOR-MERCedes, or Customer

Service (in Canada) at

1-800-387-0100.

i

For operation in the USA only:

This device complies with Part 15 of

the FCC Rules. Operation is subject to

the following two conditions:

(1) This device may not cause harmful

interference, and

(2) this device must accept any inter-

ference received, including interfer-

ence that may cause undesired

operation.

Any unauthorized modification to this

device could void the user’s authority

to operate the equipment.

컄컄

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 441 442

Comments to this Manuals

No comments