Removal & Installation (Front)
1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See
DISABLING & ACTIVATING AIR BAG SYSTEM .
2. Move appropriate front seat fully forward. Remove lower trim panel from outer edge of seat cushion
frame. Remove bolt from seat belt end fitting. Remove end fitting from seat cushion. Remove B-pillar
trim panel. Remove bolt from belt height adjuster. Disconnect ETR electrical connector. Remove ETR
bolts. Remove ETR.
3. To install, reverse removal procedure. Tighten ETR, seat belt end fitting and belt height adjuster bolts to
specification. See TORQUE SPECIFICATIONS . Activate air bag system. Read diagnostic codes and
erase memory. See DIAGNOSTICS .
Removal & Installation (Outer Rear)
1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See
DISABLING & ACTIVATING AIR BAG SYSTEM .
2. Remove appropriate C-pillar trim panel. Remove bolt from upper seat belt guide bracket. Disconnect
ETR connector. Remove bolts from ETR. Remove ETR.
3. To install, reverse removal procedure. Tighten ETR bolts and upper seat belt guide bracket bolt to
specification. See TORQUE SPECIFICATIONS . Activate air bag system Read diagnostic codes and
erase memory. See DIAGNOSTICS .
HEAD IMPACT AIR BAG MODULE (OUTER REAR)
Removal & Installation
1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See
DISABLING & ACTIVATING AIR BAG SYSTEM .
2. Remove headliner. See HEADLINER . Disconnect appropriate head impact air bag module electrical
connector. Remove screws from rear bracket. Remove screws from front and center brackets. Using
Wedge (115-589-03-59-00), remove head impact air bag module from bracket. Remove head impact air
bag module.
3. To install, reverse removal procedure. Activate air bag system. Read diagnostic codes and erase memory.
See DIAGNOSTICS .
HEADLINER
Removal & Installation
1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Remove edge trim from sliding/pop-up
roof. Remove front door seals from A- and B-pillars.
2. Remove A-pillar trim panels. Remove front folding handle. Remove sun visors and mounting clips.
Remove upper B-pillar trim panels. Remove cargo net holding point covers. Remove load compartment
handles.
3. Remove coat hooks. Remove C-pillar trim panels. Remove upper screws from D-pillar trim panels.
Detach rear headliner at roof. Lower headliner until it is supported on front seats. Lower front seat backs
rearward until sufficient access to head impact air ba
modules is available.
2004 Mercedes-Benz ML350
2004 ACCESSORIES/SAFETY EQUIPMENT Mercedes-Benz - Air Bag Restraint Systems
me
Saturday, October 02, 2010 3:40:40 PM Page 7 © 2006 Mitchell Repair Information Company, LLC.
(35 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals