Mercedes-Benz Sprinter 200 Installation Manual download pdf (Page 10)

www.dunlopsystems.com

RDW : PB-60-71/320-071/96

L.312.C.M

Mercedes-Benz Sprinter 200/300 Volkswagen Crafter 28-35

5.3 Fitting of the Air Bellow

i. Connect the air tube to the bellow, noting

colour designation : Black tube to left-hand

spring, Blue tube to right-hand spring.

Simply push-in the tube as far as it will

travel and release (see Section 5.4). Feed

the other end of the tube through the large

hole in the upper bracket.

ii. Unscrew and disconnect the load sensing

valve (LSV) linkage c from the existing

arm d. Unscrew the arm from the axle

bracket and remove it.

iii. Position the bellow between the chassis and

the axle, and attach the bottom plate of the

bellow to the lower bracket using two bolts

and two flat washers. Do not fully tighten

at this stage because the bellow may

require alignment once inflated (see

Section 5.7).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Mercedes-Benz Sprinter 200 Installation Manual Page 10