204
Control systems
COMAND navigation system (entering a destination)
It shows one of the following items of infor-
mation:
앫 Street and if necessary, house number,
city, state (USA) or province (CDN)
앫 City, state (USA) or province (CDN) and
zip code
앫 State (USA) or province (CDN) and zip
code
Which of the following menu items are now
available depends on the situation, or may
depend on the data version of the digital
map. The menu items which are not avail-
able cannot be selected.
앫 “Map”: Using the map to enter a desti-
nation (
컄 page 221)
앫 “Street”: entering a street
(
컄 page 207)
앫 “Center”: entering a center
(
컄 page 210)
앫 “POI”: entering a point of interest
(
컄 page 225)
앫 “Save”: saving a destination in the des-
tination memory (
컄 page 247)
앫 “Start”: starting the route calculation
(
컄 page 218)
왘 Continuing or completing destina-
tion entry: Select one of the menu
items mentioned above.
Entering a city
왘 In the address input menu, select
“City”.
The list of cities appears either with or
without the input characters
(
컄 page 206).
Whether or not the input characters ap-
pear depends on how many cities are
available for the desired state (USA) or
province (CDN).
i
The street and, if necessary, the house num-
ber, will then appear as soon as COMAND can at-
tribute the zip code to an appropriate address.
i
In this case, using the map for destination
entry is based on the city seen in the address in-
put menu.
i
In this case, entering a POI is based on the
city seen in the address input menu.
i
You can only enter those cities which are
saved on the digital map.
It is not possible to enter a city when you have al-
ready entered a street which COMAND can
clearly attribute to a city.
If COMAND cannot clearly attribute a previously
entered street to a city, only those cities are
available which have a street of that name.
If you have not yet entered a street before enter-
ing the city, or cities within the state (USA) or
province (CDN) previously entered are available.
Comments to this Manuals