188Interior equipment
Technical
data
Instruments
and controls
Operation Driving
Instrument
cluster display
Practical hints Car care Index
Opening the sliding/pop-up roof automatically
To select a sliding/pop-up roof opening position, press
the switch to resistance point and release it when the
sliding/pop-up roof has reached the required position.
The sliding/pop-up roof now opens to the position set if
the switch is pressed past resistance point in the “open”
direction.
If you wish to change the opening position of the
sliding / pop-up roof, move the switch to resistance point
in the direction you require.
Stopping the sliding/pop-up roof:
Move the switch in any direction.
Note:
Opening the sliding/pop-up roof automatically almost
fully (less approximately 1 inch [3 cm]), the sliding/
pop-up roof must have been opened first by pressing the
switch to resistance point and releasing it when the
sliding/pop-up roof has reached an almost fully open
position.
Warning!
When closing the sliding/ pop-up roof, be sure that
there is no danger of anyone being harmed by the
closing procedure.
If the automatic closing operation of the sliding/
pop-up roof is blocked while attempting to lower
the roof, the roof cannot be re-opened
automatically. In this case, the roof must be opened
manually.
When closing the sliding/pop-up roof with the
convenience feature and the closing procedure is
blocked, the sliding/pop-up roof will not open
automatically.
The closing procedure of the sliding/pop-up roof
can be immediately reversed by either moving the
switch in any direction, or pressing button Œ on
the electronic key and holding it; or (vehicles with
KEYLESS-GO) when carrying the KEYLESS-GO-
card, pull and hold a door handle.
When leaving the vehicle, always remove the
electronic key from starter switch, take the
KEYLESS-GO-card (if so equipped) with you and
lock your vehicle. Do not leave children unattended
in the vehicle, or with access to an unlocked
vehicle. Unsupervised use of vehicle equipment
can cause serious personal injury.
Comments to this Manuals